Bottle Information and Courses from MediaLab, Inc.

The reagent strips must be handled and stored properly in order to ensure that results are accurate. The following precautions should be observed: Store strips according to the manufacturer's recommendation. DO NOT expose strips to moisture, direct sunlight or volatile fumes. Remove only enough strips for immediate use and immediately recap the bottle. Avoid contamination of test strips. Do not touch the test areas with fingers or do not lay the test strips directly on the workbench. DO NOT use discolored strips. Compare the color of the unused strip to the negative area on the color chart provided by the company. The color should be similar. Check the expiration date. Re-label the container with a revised expiration date if the manufacturer states a shortened usage period once the container has been opened. Reagent strips must be tested periodically (frequency defined by the laboratory) for clinical reactivity with normal and abnormal urine controls. Urine controls are available commercially or may be prepared and preserved in-house.

A 63 year old man was seen in the emergency room with the complaints of sudden onset of fever, chills, and abdominal pain, accompanied by mild diarrhea. The blood pressure was 140/84, the pulse rate 82/minute, and the body temperature 39.8C. A blood sample was drawn for a complete blood count, and a blood culture.A second blood culture was drawn from the opposite arm, with 10 ml of blood being placed into each an aerobic and an anaerobic bottle, following customary practice.The complete blood count revealed a hemoglobin of 15.8 mg/dl, a hematocrit of 45%, and a white blood count of 4.2/L. The neutrophils were 39%, lymphocytes 45%, monocytes 10%, eosinophils 4% and basophils 2%. The platelet count was 255/L. The patient was admitted to the hospital for further work-up and empiric antibiotic therapy.Within 24 hours after admission, the body temperature had decreased to 38.2C, although the mild diarrhea persisted.A stool toxin test for Clostridium difficile was negative and neither enteric pathogens nor Campylobacter species were recovered in stool culture after 24 hours incubation. Fecal neutrophils were not seen on direct examination. The anaerobic blood culture became positive 36 hours after inoculation.

In follow up to the previous question, the upper image again illustrates the colonies recovered from the blood culture bottle. The colonies are small, transluscent, gray-yellow, and surrounded by a wide zone of beta hemolysis.The size of the colonies compared to the zones of hemolysis suggests a group A streptococcus.The susceptibility to bacitracin (zone of inhibition around the "A" disk)(lower photograph) is virtually diagnostic of a group A streptococcus.The absence of a zone of inhibition around the SXT disk indicates resitance to sulfamethoxazole/ trimethoprim. SXT resistance is also shared by group B streptococci, which are, however, resistant to bacitracin.The resistance to SXT is used for the primary recovery of groups A and B streptococci from specimens with mixed culture. Their resistance allows them to selectively grow out from contaminating bacteria that are inhibited by this antibiotic.

Blood for culture can be collected in several ways:Standard needle attached to a syringe.Butterfly needle attached to a syringe.Blood culture bottle attached directly to tube holder (not generally recommended).Follow you own facilities’ procedure for blood culture collection.

After collecting the blood, activate the needle safety device according to manufacturer’s instructions, and place it in a sharps disposal container. If blood was collected into a syringe, insert the syringe tip into the hub of a blood transfer device, and rotate the syringe clockwise to secure it to the device. Push the blood culture bottle into the holder of the transfer device, and draw the appropriate volume of blood into the blood culture bottles.